Reihen- und Parallelkondensator-Rechner
Ersatzkapazität aus einer Kondensatorliste
Required Parameters
Waiting for input data...
Quick Answer
Capacitors in parallel ADD: C_total = C1 + C2 + ... Capacitors in series use the reciprocal formula: 1/C_total = 1/C1 + 1/C2 + ... This is the OPPOSITE of how resistors combine.
Reihen-/Parallelkondensator-Rechner
Berechnen Sie die Ersatzkapazitaet von Kondensatoren in Reihen- oder Parallelschaltung.
Parallelschaltung
Cgesamt = C1 + C2 + C3 + ... + Cn
Reihenschaltung
1/Cgesamt = 1/C1 + 1/C2 + ... + 1/Cn
Verwandte Werkzeuge
- Widerstandsrechner
- Reaktanzrechner
Design Notes
Capacitor networks are everywhere in electronics. Parallel combinations increase total capacitance and reduce ESR — essential for power supply decoupling where multiple small MLCCs outperform one large electrolytic. Series combinations increase voltage rating at the cost of capacitance. When mixing types in parallel (e.g., 100µF electrolytic + 100nF ceramic), each type handles a different frequency range, providing broadband filtering.
Common Mistakes
- 1
Confusing capacitor series/parallel rules with resistor rules — they are OPPOSITE. Capacitors in parallel add (like resistors in series).
- 2
Putting capacitors in series without balancing resistors. Without equalization, voltage distributes unevenly and one capacitor may exceed its voltage rating.
- 3
Using only large capacitors for decoupling. Large caps have high ESL and poor high-frequency response. Always add small MLCCs in parallel.
Engineering Handbox
1. Parallel: simply add all values 2. C_total = 10 + 22 + 47 = 79 µF 3. For series: 1/C = 1/10 + 1/22 + 1/47 = 0.1 + 0.0455 + 0.0213 = 0.1667 4. C_series = 1/0.1667 = 6.0 µF
Knowledge Base
Wie verhalten sich Kondensatoren parallel?
Parallelkondensatoren addieren sich direkt: C_ges = C1 + C2 + ... Das ist das GEGENTEIL von Widerständen.
Was ist die Formel für Kondensatoren in Reihe?
1/C_ges = 1/C1 + 1/C2 + ... Das Ergebnis ist immer kleiner als der kleinste Einzelkondensator.
Warum Kondensatoren in Reihe schalten?
Um die Spannungsfestigkeit zu erhöhen. Jeder Kondensator sieht nur einen Teil der Gesamtspannung. Ausgleichswiderstände sind nötig.
Kann ich verschiedene Typen parallel schalten?
Ja, das ist sogar Best Practice: z.B. 100µF Elko + 100nF Keramik für breitbandige Entkopplung.
Was ist ESR bei Parallelkondensatoren?
Der ESR (Equivalent Series Resistance) sinkt bei Parallelschaltung, was weniger Rippelspannung und schnellere Transienten bei Netzteilen bedeutet.
Related Engineering Tools
Low Pass / High Pass Filter Calculator
-3 dB cutoff for RC and RL filters
Reactance Calculator
Inductive and capacitive reactance
Time Constant Calculator
RC and RL transient constant
Capacitance Conversion
Unit conversion and basic capacitor code decoding