Kondensator-Entladerechner
Entladezeit oder Widerstandswert berechnen
Required Parameters
Waiting for input data...
Quick Answer
A capacitor discharges through a resistor following V(t) = V₀ × e^(-t/RC). The discharge time to a safe voltage is t = R×C × ln(V_start/V_end). Always verify with a voltmeter — capacitors can hold lethal charge for hours.
Kondensator-Sicherheitsentladungs-Rechner
Berechnen Sie die Zeit zur sicheren Entladung eines Kondensators ueber einen Entladewiderstand.
Entladeformel
U(t) = U0 x e^(-t/(R x C))
Verwandte Werkzeuge
- Zeitkonstanten-Rechner
- Reaktanzrechner
Design Notes
High-voltage capacitors are one of the most dangerous components in electronics. A 400V 1000µF capacitor stores 80 joules — enough to kill. Always include bleeder resistors in power supply designs. UL/IEC standards require discharge to <50V within 1-5 seconds of power removal. Balance the bleeder resistance: too low wastes power continuously; too high takes too long to discharge safely.
Common Mistakes
- 1
NEVER short-circuit a charged capacitor to discharge it. The instantaneous current can weld contacts, damage the capacitor, and create dangerous arcs.
- 2
Relying on self-discharge — film capacitors can hold a charge for months. Always use a discharge resistor.
- 3
Forgetting to account for the bleeder resistor's power dissipation when the circuit is energized: P = V²/R.
Engineering Handbox
1. Time constant: τ = 10,000 × 470×10⁻⁶ = 4.7 seconds 2. Voltage ratio: ln(400/50) = ln(8) = 2.08 3. Discharge time: t = 4.7 × 2.08 = 9.8 seconds 4. Stored energy: E = ½ × 470µF × 400² = 37.6 J
Knowledge Base
Wie lange muss ein Kondensator entladen werden?
Mindestens 5 Zeitkonstanten (5τ = 5RC) für 0,7% Restspannung. Dann mit Voltmeter verifizieren. Bei >50V auf 7–10τ warten.
Warum brauche ich einen Entladewiderstand?
Große Kondensatoren können stunden- oder tagelang tödliche Ladung halten. Ohne Bleeder-Widerstand ist Selbstentladung viel zu langsam.
Wie berechne ich die Entladezeit?
t = R × C × ln(V_start / V_end). Beispiel: 470µF, 400V→50V, 10kΩ: t = 4,7 × 2,08 = 9,8 Sekunden.
Wie viel Energie speichert ein geladener Kondensator?
E = ½CV² in Joule. 1000µF bei 400V = 80J. Schon 1 Joule über das Herz kann tödlich sein.
Darf ich einen Kondensator kurzschließen zum Entladen?
NIEMALS. Der Stromstoß kann Kontakte verschweißen, den Kondensator zerstören und gefährliche Lichtbögen erzeugen. Immer Entladewiderstand verwenden.