Calculadora de Convertidor Buck/Boost
Ciclo de trabajo, inductor y rizado
Required Parameters
Waiting for input data...
Quick Answer
Buck duty cycle: D = Vout/Vin. Boost duty cycle: D = 1 - Vin/Vout. Minimum inductance: L = Vout(1-D)/(2·f·ΔIL).
Design Notes
Switching converters are far more efficient than LDOs (85-95% typical). The inductor must handle peak current without saturating. Output capacitor ESR dominates ripple voltage. Use ceramic caps for low ESR. Higher switching frequency allows smaller inductors but increases switching losses.
Common Mistakes
- 1
Using ideal duty cycle without accounting for diode/MOSFET drops and DCR losses.
- 2
Selecting an inductor based only on inductance — saturation current rating is equally critical.
- 3
Ignoring input capacitor requirements — buck converters draw pulsed current that causes input ripple.
Knowledge Base
¿Qué es un convertidor buck?
Reductor DC-DC eficiente. Ciclo de trabajo D = Vout/Vin. A diferencia de los LDO, logra 85-95% de eficiencia conmutando rápidamente y almacenando energía en el inductor.
¿Cómo elijo el inductor?
Inductancia: L = Vout(1-D)/(ΔIL×fsw). Corriente de saturación: 20% sobre pico. DCR bajo. Valores típicos: 4.7-22µH para 500kHz-2MHz.
¿Qué frecuencia de conmutación usar?
100-300kHz (potencia alta), 500kHz-1MHz (mayoría), 2-3MHz (compacto). Mayor frecuencia = componentes más pequeños pero más pérdidas de conmutación.
¿Qué ICs son populares?
Buck: MP2315 (3A), TPS54331 (3A), LM2596 (clásico). Boost: MT3608 (2A, barato). Buck-Boost: TPS63000 (Li-ion a 3.3V). Módulos: LM2596 y MP1584.
Related Engineering Tools
Battery Life Calculator
Estimate runtime from capacity and load current
Three Phase Calculator
Real, apparent, and reactive power
Transformer Turns Ratio Calculator
Voltage, current, and impedance transformation
LDO Voltage Regulator Calculator
Dropout, power dissipation, and thermal analysis